Vintage Tube Amp

Confirmed power on only, so it is treated as junk. The product contents are everything shown in the images.

EXCELLENT APPEARANCE, TOP EXAMPLE IN SOUND, MINT! Recapped where needed which was very little! All vintage tubes, no modern eastern European or Chinese tubes! The 4 Toshiba Main Power Output tubes are Vintage. New lamps, Tuner aligned, completely gone through! Only one available with all these services! With the services provided, this amp sounds more like a modern 120-Watt amplifier! The Rolls Royce Phantom of vintage tube receivers! Type: Receiver, tube technology. Years of manufacture: 1969 – 1971. Color: silver, housing metal. Dimensions: 416 x 145 x 300 mm (WxHxD). Weight: 44.7 lbs. Phono MC 1: 0.06 mV. Phono MM 2: 2.5 mV. Microphone: 1,8 mV. Tape Head: 2,0 mV. Tape Play: 150 mV. Tape Play DIN: 150 mV. Aux 1: 65 mV. Aux 2: 110 mV. Tape Rec: 200 mV. Tape Rec DIN: 35 mV. Headphones (6.3mm jack). 2 pairs of loudspeakers. Continuous power (at distortion). 4 Ohm: 2x 40 W. 4 Ohm: 2x 50 W. Attenuation factor: 9.5 (at 8 Ohm). High Level: 20 – 20’000 Hz. Signal to noise ratio. High Level: 90 dB. Bass at 100 Hz: ± 10 dB. Treble at 10 kHz: ± 10 dB. Loudness: yes, +6 dB at 100 Hz, +3 dB at 10 kHz. Low Filter: yes, 6 dB / octave at 30 Hz. High Filter: yes, 6 dB / octave at 8 kHz. FM: 88 – 108 MH. Frequency response: 30 – 15,000 Hz (+0.2/-0.5 dB). FM (65 dBf): 75 dB (mono), 66 dB (stereo). Channel separation: 35 dB (1 kHz). Co-wave selection: 2.7 dB.

Missing 4 output tubes (6BM8). Has slight surface rust all over. Knob on left is not original. Weighs about 29 lbs before packing. Terminals in rear have separation – see pics. The screws that hold cover on were missing so I put 4 in, but not original. There may be some things I missed. See pictures as they are part of the description.

Thank you for visiting my page! This is a single OPT with a primary side of 7K? , ideal for ST tubes such as 42 and GT tubes such as 6F6. Regarding accessories, you will only receive the products shown in the photo. Please see photos and video if available. We will pack the product securely and deliver it safely. International Buyers – Please Note. We do not mark merchandise values below value or mark items as “gifts” Because declared value is insured value. Besides US and Int. Ernational government regulations prohibit such behavior. Japanese mechanical products use 100 volts. A transformer is required if it does not match your country’s voltage. Do your own research and prepare a suitable transformer. We try to describe any items to the best ability and offer you the best values and an good quality. We specialize in Japanese tradition products, so please look at our other items and enjoy feeling Japanese culture! Maybe we can find it for you.

This item is for parts only in non working condition. This Sansui 1000 Tube Receiver is a rare find for vintage electronics enthusiasts. With its unique features and untested status, it’s a perfect addition to any collection. The brand, Sansui, is known for its high-quality audio equipment, making this receiver a reliable choice for vintage audio and video setups. The receiver is categorized under Consumer Electronics, Vintage Electronics, Vintage Audio & Video, and Vintage Stereo Receivers, making it a highly sought-after item. Don’t miss the chance to own a piece of vintage electronics history.

Unit has a new 12AU7 tube. AUX input and Phono inputs. Unit was stored for many years but has been used for weeks to fully test. Unit carefully wrapped in bubble wrap then enclosed in box, sealed and then placed in larger heavy duty box where it is surrounded by hard foam strips which will allow your unit to arrive undamaged.

Has slight surface rust all over. The screws that hold cover on were missing so I put 4 in, but not original.

Has slight surface rust all over. The screws that hold cover on were missing so I put 4 in, but not original.

Tested and Working well. There are some scratches, but no problem with playing. Please have a look at the photo. This product is well sterilized and disinfected. Inputs from AUX and phono have been checked, VR and balance have been replaced, I did not feel any buzzing in the VRs, balance did not change, inside has been cleaned, most of the capacitors have been replaced and there are signs of maintenance, panel color is uneven, knobs are not original, maintenance is scheduled to be completed in the near future. The knobs are not original and may require maintenance. Other items have not been checked, please judge from the photos. We will determine the arrival date based on the tracking information. Thank you for your understanding. If that, please let us know within 3 days you got the item. This item is in the category “Consumer Electronics\Vintage Electronics\Vintage Audio & Video\Vintage Amplifiers & Tube Amps”. The seller is “retorstore-music-jp” and is located in this country: JP. This item can be shipped to United States, all countries in continental Asia, United Kingdom, Germany, France.

• Brand: Sansui
• Type: Integrated Amplifier
• Custom Bundle: No
• Model: Sansui AU-111
• MPN: NA
• Country/Region of Manufacture: Japan
• Modified Item: No

All items in my store are 100% authentic. Please contact me if you have any questions. About Importer’s Obligation. We do not mark merchandise values below value or mark items as “gifts” – US and International government regulations prohibit such behavior. Thank you for your understanding. This item is in the category “Consumer Electronics\Vintage Electronics\Vintage Audio & Video\Vintage Amplifiers & Tube Amps”. The seller is “kj-japan” and is located in this country: JP. This item can be shipped worldwide.

• Brand: Sansui
• Serial number: 606078858
• Type: Tube Amplifier
• SNR: 115dB or more
• Custom Bundle: No
• Model: AU-X111MOS VINTAGE
• Power consumption (W): 350W
• impedance: 4 to 16Ω
• MPN: AU-X111MOS VINTAGE
• Frequency response: DC to 300kHz +0 -3dB
• Modified Item: No
• Rated output: 150W+150W(6Ω) 110W+110W(8Ω)