Vintage Tube Amp

This is a LUX SQ-38D vacuum tube amplifier. Being a very old used item, it has scratches from use, please check the photos for the condition. The amplifier was previously used by a family member as a hobby, but has been stored in a warehouse for about 20 years. When connecting a PC to AUX-1 and connecting speakers to SPEAKERS L R’s 0 and 8? , sound was confirmed on R, but no sound was produced on L. When connecting a PC to AUX-2 and connecting speakers to SPEAKERS L R’s 0 and 8? , sound was produced on both L and R. When connecting a PC to TAPE and connecting speakers to SPEAKERS L R’s 0 and 8? , sound was produced from both L and R, but the sound was muffled and quite poor. Operation of PHONO 1 and 2 has not been confirmed. The MODE was tested in stereo only; other modes were not checked. The BALANCE was responsive.

This is a used Lux vacuum tube amplifier that has been tested. It requires four 6RA8 vacuum tubes to operate (not included). Deteriorated components such as capacitors have been replaced. The main unit has scratches and rust, but there are no severe stains or dents.

Vintage Luxman Tube / Valve Amplifier, Model #LV-105(U). In very good condition. Tested and working, sounds good. Will be packed well with bubblewrap.

Product is in great working condition. Tested and sounds fantastic. Unit was fully serviced. Tube type control amplifier. 3 Hz to 70 kHz – within 1 dB. Total harmonic distortion factor. 0.008% (20 Hz to 20 kHz at 2 v output). Pre out : 560? Rec out : 680? Phono1, 2 : 2 mV Tuner, aux : 170 mv. Phono1, 2 : 50k? Tuner, aux : 70k? Signal-to-noise ratio (IHF-A corrected). Phono1, 2 : 80 dB Tuner, aux : 100 dB. 300 mv (phono, 1 khz, RMS). ± 0.3 dB. Turnover : 3 kHz Variable range : + / – 8 dB. Turnover : 300 Hz Variable range : + / – 8 dB. Filters (subsonic, defeat, low cut) Two tape monitors Tape dubbing Attenuator Two AC outlets. Vacuum Tubes (8 pcs). 12AX7 : 4 12AU7 : 4. 60W (Electrical Appliance and Material Control Law). Width 438x Height 77x Depth 322 mm With Wood Case : Width 464x Height 120x Depth 338 mm.

The amplifier has no sound from the right channel. NO Carrier Service Drop Off. [West Side, Cheviot / Westwood Area].

Please check the status description. All of our goods are genuine articles. Moreover, we sell honestly. Please contact me, if you have your question. International Buyers – Please Note.

LUXMAN Luxkit A3500 Power Amplifier Tube Main Amp Kit Vintage Working Tested F/S. Thank you for watching. Vacuumtube Amplifier vacuum tube amplifier. No accessories in particular. Fully working / no problem. ¦ External dimensions W: 465 H: 168 D: 206 mm. ¦ Weight 16 kg. Please judge the condition by the pictures. I will answer any questions you have about the product to the best of my knowledge. Each piece is carefully packed and delivered to the customer. And please take care of our shop. International Buyers – Please Note. Thank you for your understanding.

UsedThis product works fine. Since it is 100V, please prepare a transformer that matches the voltage of your country. Please check all the photos before purchasing and make sure you are satisfied before purchasing. We do not mark merchandise values below value or mark items as “gifts” – Japan, US and International government regulations prohibit such behavior. About Importer’s Obligation. Thank you for your understanding.

For sale a LUXMAN model SQ5Bb tube amplifier (circa 1965) in really excellent condition. Amplifier was carefully tested and in good working order, no issues. There are inputs for PHONO, TUNER, TAPE. The output tubes – 6BQ5 (EL84). Amplifier operates on 120V. Specifications: Output and a distortion – 14W+14W (50Hz), less than 1% Frequency characteristic Less than [20Hz-20000Hz 1dB] Input sensitivity/impedance: (10W, 1kHz) Tape: 2mV/100kohm MAG: 3.5mV/100kohm Tuner, X’TAL:270mV/2Mohm Output-terminals – 4ohm, 8ohm, 16ohm, 32ohm S/N ratio (volume maxima) Tape:52dB MAG:60dB Tuner, X’TAL:65dB Tone control With the LUX scheme NF type it1 stopper: 16dB Equalizer Tape:NAB MAG:RIAA Attachment Tapes monitor DIN recording-play connector The semiconductor used Tubes: 3 – 12AX7, 2 – 6AN8, 4 – 6BQ5(EL84) Power consumption 110W Dimensions Width 390x height 155x depth of 290mm Weight 11.2kg Check my other ads for more quality vintage electronics.