The capacitors looked good enough to at least plug the amplifier in & it did not blow any fuses/transformers. The power indicator light up. All 4 rubber feet on the bottom are hardened and should be replaced. The presence, scratch filter & rumble filter knobs can all be pressed in. All knobs adjust freely. There is some dust/aging almost everywhere on this amp, but I’m sure it would clean up nicely with proper attention to detail. This was an estate find & I do not know how long it was sitting – I would assume that some work. From a smoke & pet free environment. Device will be packaged with extreme care. Reference the photos and description carefully to see the quality of the exact product you will receive. Please reach out with any questions!
Price Reflect a Clean Unit, Fresh Total Restoration and All Vintage either NOS or NOS Tested Balance Premium Tube Complement Mullard-Great Britain, EU-E. Long Life vacuum tubes. THIS UNIT IS CROSS LISTED On Multiple Sites. Pick the lowest cost rate to your zip code and we will make it happen. This is a Very Long Detailed Description (NO A/I listing descriptions used here). ONE(1) FRESH Electronic Restoration(05/17/2025). 1959 SHERWOOD S-5000 (S5000) version=I (S-5000 I) Stereo 12-Tube Integrated Amplifier. RE-Tubed with Premium Tubes. All vintage US, Great Britain, E. Germany-Russian vintage tested tubes on a recently Dan Nelson Calibrated TV7D/U tester. SN# 955418 Production of the Sherwood S-5000 ca. Unit will come with Printed copies of the Service manual all SKU’s, parts list, trouble shooting tips ect. And Sherwood S5000 User/Operation/Setup Manual with Diagrams and full Operating Specs. Included Excellent Condition Original Metal Cabinet, Bottom Panel and all original knobs. This unit is In working and excellent sonic condition. Fully tested after restoration for 20hours Stereo&Mono all Line Level channels with CD player&Cassette Player/Aux, TV & Tape input and also tested both High-Level and Low-Level Phono Channels with a Phillips 312/Stanton EE980 cart. The chassis is grounded for connection to your turntable ground wire connect to one of the side panel nut/bolt/screws. Original 1959 Excellent Quality Power Supply Stamped in metal’B9922J3-3 A949937. And Two(2) Original Ultra linear Output Transformers’B920J4 M549935′ all 3 PS/OPTs with Braided Cloth wiring. P ower output: 20 watts per channel into 8? (stereo). Frequency response: 20Hz to 20kHz. Total harmonic distortion: 0.5%. Input sensitivity: 2mV (MM), 200mV (line). Signal to noise ratio: 60dB (MM), 80dB (line). Speaker load impedance: 4? , 8? , 16? Valve complement: 4 x 7189(EL84/6BQ5/E84L/7320), 2 x 7199, 5 x 12AX7/ECC83, 1 x 5AR4/GZ34. Notes on Power tubes: 6BQ5/EL84′s ave. Life 500 hours, 7189=6BQ5B 1,000 hours average. E84L/7320 premium tubes average life 5,000 hours. Dimensions: 14 x 13.5 x 4 inches. Net weight: 32.5 lbs (amp with tubes and shields). Vacuum Tube Complement (mixed Vintage USA, Great Britain, East German/Russian). 4xNOS Date Matched(’79-22′) Quad E84L’s/ 7320 Gold Pins branded for DuMont The E84L/7320 is a premium Long-life version of. 7189′s= /6BQ5B/ which were upgraded versions of EL84′s/6BQ5′s. Quad is white inked “Made in Germany” “7320/E84L”. Then Red ink “ERP” “79-22″. This quad have solid disk top-side getter with a center dimple and were either made in East Germany or made by Reflector in Sartov, USSR to Russian military specs for export. 5x 12AX7/A’s 3 are Mullard inked’Great Britain’ 1965′I63′ 2x’B5J4”B5K2′ inked’Made in Great Britain’ branded for GE. The 4th is a late 1960′s’IE’ GE 7025/12AX7A(best inserted in V1-for low noise phono amplifier tube) and the 5th is a GE 12AX7A dated 1964. All tubes tested balanced and strong. 2x 7199 vintage 1960′s Black Plate USA tested trong. One RCA(early 1960′s) and one Westinghouse(1967). 1x5AR4/GZ34 NOS unused Sovtek(Tested very Strong NOS+ balanced plates dated 2001 Russia -High reliability tube). Notes: Our 50years+ exp. With Cabinets/Cages/Covers/Consoles enclosures : cabinets, metal cages and Console Enclosure hinder air-flow and as such your tubes will only generally last 1/2 as long. So we suggest operating this Sherwood S-5000 outside of its cabinet for daily use. We also suggest using all tube audio units in operation without covers. Additional we suggest using a high quality computer fan behind these tube type units to dissipate vacuum tube heat (just visit your local Computer repair/parts store many have fans available for low cost). In 2025 a NOS vintage tube complement(12 Premium tubes) in these units cost was as much as an unrestored unit with average/user supplied used tubes. A Light that burns twice as bright(twice as Hot without ventilation) burns 1/2 as long’. Please Follow this suggestion and Your tubes will love you! This Unit&Cab, Tubes and all Docs with this printed description will then all be packed into a New Heavy Duty ULINE/UHAUL Small Electronics box 20″x20″x10 all 6 sides will have ample thick Styrofoam padding. Restoration work done to Factory Specifications. Full Details of restoration are below. Please read our feedback from very recent sales of Tube Audio PreAmps Dyna PAS-2, Valve Audio Labs MP-L1S MKII. Extensive published docs, Installation User Setup and Operation, All Tech Specs, -Freq Response Graphs, Fold-out SKU’s, Full Parts List, many Diagrams + MUCH MORE. ALL PARTS AND TUBES ARE MARKED and IDENTIFIABLE in PICs and PCB boards and chassis assembly marked Invisible uv inked. Some of the electronic part/s may continue for another 60 years without need of replacement and some electronic part/s may fail a few days after you start using the item. This unit just back 05/17/2025 from a complete servicing/restoration by a Radio/HiFi/Ham Restoration Professional with 50 year Radio, HiFi Analog & Solid State restoration experience. Re-Tested all resistors and capacitors for spec’ed tolerances a Labor of Love! Replaced 2 out of tolerance resistors this unit was a quality build w/ Allen-Bradley Mil-Spec’ed High Quality resistors. Seems Sherwood used high quality parts suppliers in this model S-5000 build. I counted 28 caps changed from a few old wax and many PIO caps. Changed old caps to NOS Polyester/Mylar’EM’ CDE tone caps, Upgraded the Power output By-pass caps from 0.068 mF 400VDC 20% to 600VDC 10% to upgrade power reserves with low tolerance to potential failure going forward. Replaced AC line Chord to a new heaver duty 2-prong(Chassis is Grounded). Cleaned all Tube Sockets, Switches, Pots & Contacts with CRC QD electrical contact cleaner then Deoxit5 electrical lubricant. Pulled and replaced all Vacuum Tubes with either NOS or TV7D/U tested Strong & Balanced replacements high quality replacements. Detailed the front faceplate for with microfiber and Flitz to remove metal oxidation. Hifiengine: hifiengine dot com/manual_library/sherwood/s-5000 dot shtml_. Power output: 20 watts per channel into 8? (stereo). Speaker load impedance: 4? To 16? Valve complement: 4 x 7189, 2 x 7199, 5 x 12AX7/ECC83, 1 x 5AR4/GZ34. Net Dimensions: 14 x 13.5 x 4 inches. Please see all 24 pics posted. JUST SELECT THE LOWEST COST SHIPPER. Net dims: 14″W X 13 1/2: D X 4″H. Kg / 32 lb. Glass tubes will be pulled and packed into a separate box, The amp will be placed inside the metal cabinet. Tubes & Tube shields will be pulled and packed well inside the a separate box. Be Patient with the Setup & Reinstallation of all the 12 VACUUM TUBES. Carefully unpack the unit and the tubes. Remove the metal cover. Insert the tubes in there proper sockets. Connect your Speakers wire pairs to the matching 16/8/4 ohm screw connectors on the back panel with Proper Phase’+’ =Red=hot connect to either 16/8/4 ohm back panel screw and the other wire to’-’=White or Black=COM screw on the back panel. NEVER turn on AC Power or Operate any Amp/Integrated Amp or Receiver without a pair of Speakers connected to the correct Ohm reading of the speaker. (This is called speaker loading). If you turn on any amp without speakers connected(a Load) you might damage the Output Transformers. Then connect your input devices : CD/Tape and any other Line Level device and/or your turntable to either High-level or Low level(phono cartridge) into there indicated back panel rca inputs. Then plug in the line chord and turn the power on this integrated amp. THANK YOU FOR LOOKING!
Sherwood S-5000 II Tube Amplifier and S-2200 Tuner Cleaned & Tested HIFI. Both units were tested and cleaned. Tubes were tested and faulty ones were replaced. Feel free to reach out with any questions and thank you for looking. Power output: 36 watts per channel into 8? (stereo). Frequency response: 20Hz to 20kHz. Total harmonic distortion: 1.5%. Input sensitivity: 1.8mV (MM), 350mV (line). Signal to noise ratio: 60dB (MM), 90dB (line). Speaker load impedance: 4? To 16? Valve complement: 6 x 12AX7, 4 x 7868. Dimensions: 14 x 12.5 x 4 inches.
Vintage Sherwood S5500 S-5500 Tube Stereo Integrated Amplifier Amp. The Sherwood S-5500 is a vintage tube stereo integrated amplifier, known for its rich, warm sound and classic design. A cherished piece among audiophiles, this amplifier delivers exceptional audio quality with the timeless appeal of vacuum tube technology. Type: Tube Stereo Integrated Amplifier. Tube Configuration: 7591 power tubes. Frequency Response: 20Hz – 20kHz. Inputs: Phono, Tuner, Aux. Outputs: Speaker terminals, Tape Out. Impedance: 4? , 8? , and 16? Speaker compatibility. Tone Controls: Bass, Treble, Balance adjustments. Construction: Metal chassis with vintage-style knobs. Classic tube sound with warm, natural audio reproduction. Hand-wired circuitry for superior build quality. Multiple inputs for turntables, tuners, and auxiliary devices. Vintage aesthetic with durable metal construction. Powerful output suitable for a variety of speaker types. The knobs are worn, and the front panel shows some age and yellowing. F1 – Collectible or Specialty Equipment. Equipment in this category prioritizes rarity or unique features over functionality. Collectibles are rare, vintage, and no longer manufactured or supported by the OEM. Specialty equipment is rare and specialized equipment not generally available in retail. These units may have broken or missing parts, but its collectability holds greater value. C3 – Used Fair. Moderate scratches or scuffs. Possible small dings or dents. Some discoloration may be present. Hinges may be a little loose. Device has been assessed as a device that does not contain data, or data has been physically removed. Please plan your orders accordingly. For items that are tested and working properly: Our return window for working items listed as “New” or “Used” is 30 days.
This vintage Sherwood S-5000 II integrated tube amp is a true gem for any audiophile. Made in the United States, this classic piece boasts a timeless design and top-notch sound quality. With its Cooper HiFi technology, you’ll enjoy a rich, warm sound that’s perfect for any music lover. This amp is perfect for those who appreciate vintage audio and video equipment. It’s a great addition to any collection and is sure to impress. Don’t miss out on this opportunity to own a piece of audio history.
VINTAGE SHERWOOD S-1000 III MONO TUBE AMPLIFIER. Very Good Condition – See Pictures. Pots / Switches Cleaned. Very Hard to Find – Collectible. Power output: 40 watts. Frequency response: 20Hz to 20kHz. Total harmonic distortion: 0.5%. Input sensitivity: 1.8mV (MM), 180mV (line). Signal to noise ratio: 60dB (MM), 80dB (line). Speaker load impedance: 4? To 16? Valve complement: 4 x 6BQ5/EL84, 1 x 7199, 2 x AX7/ECC83, 1 x 6AQ6, 1 x 5AR4/GZ34. Dimensions: 14 x 10.5 x 4 inches.
This vintage Sherwood S-5500IV stereo amplifier is a must-have for any audiophile looking to add a touch of nostalgia to their collection. Featuring a brand name that is synonymous with excellence, the Sherwood S-5500IV is a vintage amplifier that has stood the test of time. The perfect addition to any vintage audio setup, this tube amplifier is sure to impress even the most discerning of listeners.
This wasn’t serviced as it seems to be working just fine. Without even using an external antennae the unit pulled in local stations. The cat’s eye tube is working and is very cool.
