McIntosh MC240 power amplifier in beautiful condition. This is the earliest version of this amplifier released in 1960. The amplifier has been completely restored with new power supply, capacitors, and resistors by Fuchs Audio in New Jersey. The amp comes with 4 NOS GE 6L6GT power tubes, 2 NOS RCA 12BT7 tubes, and JJ 12AX7 tubes. The amp is warm sounding with incredibly deep bass and clarity, even by modern standards.
This unit has undergone an extensive electronic restoration here at Novalux Stereophonic. The unit has also received a fresh set of tubes. There is a McIntosh clinic sticker on the front of the unit which has been left in place for historical context.
Here we have a very clean McIntosh MC240! This was the first stereo amp introduced by McIntosh… This particular unit was boxed up in storage by previous owner for quite some time. I powered the amplifier up very slowly with a variac and it performs like a real champ! There is no hum from the amp and the sound quality is good, but the tubes have not been tested and a new set of quality matched tubes should make a marked improvement. Most of the tubes are Zenith, one is RCA, one with worn off markings. I believe this could be an early production model. I’ve provided the photos which should help date the unit. The circuitry appears to be all original. Please note chassis stamp number 133. Also rubber stamp numbers on inside chassis. Included is a photo of the backs of the potentiometers which should help date this amp. Switches and pots are all working well and sound clean. Chrome is in especially nice condition and silk screen lettering in in very good condition but a little wear on some letters. Also please note that the top left corner of the Right speaker terminal strip is broken and the screw has a larger head compared to the others and was probably swapped out at one time. Other McIntosh listings coming soon! C-22, MR71, C4s, C-8, C-108, MX110.
This listing includes a Vintage McIntosh MC240 Audiophile Stereo Vacuum Tube Power Amplifier. Offered in used condition, was tested and is fully functioning with a clean otput. We cleaned / lubed all contacts. Salesbaron is in Los Angeles, 90039. All major credit cards. Filing a claim should be reserved as a last resort to solving an issue. Please give us a chance to solve any issues that you may have for any reason before leaving feedback.
Thank you for looking! I have done all the maintenance. The output tube is an RCA printed one. The power voltage selector switch is fixed at 117V. (Please use at around 100-110V). ¦ International Buyers – Please Note. Buyers are responsible for paying import charges. We do not mark merchandise values below value or mark items as “gifts” Because declared value is insured value. Besides US and International government regulations prohibit such behavior.
McIntosh MC240 Stereo Tube Power Amplifier Vintage. Famous Macintosh MC240 tube power amplifier There are peeling of letters and plating dullness due to aged deterioration. I use a Japanese post office. International Buyers – Please be careful? ·For used items: We can’t guarantee long term operation or discoloration. Thank you and best regards.
McIntosh MC240 Vintage Tube Amp – SkyFi Restored w/Premium Vintage Tubes. General: We painstakingly restored this classic and coveted stereo tube amplifier to its full glory. Internally we replaced every critical component while carefully maintaining the original sonic quality. This listing also includes a rare and correct McIntosh tube cover (tube cage). SkyFi Restoration Notes: This MC240 underwent an extensive electronic restoration in house. The electronic work included a full rebuild of the power supply using custom made multi-section capacitors that match the exact values and layout of the original power supply. The bias supply was also rebuilt with new parts. The selenium bias diode was swapped to silicon with proper adjustment resistor to maintain the ideal bias level for the unity coupled output section. We also replaced all of the paper and di-film capacitors in the signal path after finding them leaky and drifted. During the signal path capacitor replacement we checked all of the resistors and replaced any parts that had drifted out of tolerance. By default we replace the phase inverter balancing resistors and plate load resistors with precision metal film parts to ensure trouble free performance. To finish up, we replaced the power cord and inrush current thermistor. Tube Notes: This amplifier is fitted with a set of premium vintage tubes. The output tubes are RCA 6L6 (2) are labeled McIntosh at the base. All four are RCA made tubes. The two labeled RCA have brown colored getter flashes but still test strong and sound great! The 12BH7 are strong matched and balanced GE. The remaining tubes are all strong testing authentic Telefunken 12AX7 and 12AU7. Cosmetic Notes: This MC240 was well loved. It has moderate chrome pitting and light silkscreen wear which is common for McIntosh amplifiers from this era. There are also some scratches/markings on the black transformer covers and cage. Two historic Dave O’Brian clinic stickers flank the McIntosh 240 badge and show years 1971 and 1972. The company was founded in 1949 by Frank McIntosh. The company designs and produces audio amplifiers, stereo tuners and other consumer electronics products. Ownership: Unknown Connections: RCA Inputs, Screw Terminal Outputs General Sound: Smooth, uncolored, undistorted natural and clean Cosmetic Condition: 6 / 10 Working Condition: Working perfectly and tested in our lab and listening room. Included: Unit, power cord, manual, and tube cage. Packing: Will be packed using our highly developed in-house process and custom packing materials. Specs: Power output: 40 watts per channel into 8? (stereo), 80 watts into 2? (mono) Frequency response: 16Hz to 40kHz Total harmonic distortion: 0.5% Input sensitivity: 0.5V Signal to noise ratio: 90dB Speaker load impedance: 4? Tube complement: 1 x 12AX7, 2 x 12AU7, 2 x 12BH7, 2 x 12AX7, 4 x 6L6GC Dimensions: 17-1/4″ x 10-3/4″ x 8 Weight: 56 lbs. Testing Process: The SkyFi Testing Process for Tube Amplifiers: We start with a visual inspection of all internal components to make sure that there are no signs of heat stress or damage. Capacitors are checked for telltale signs of predictive failure including bulging, shrunken wrappers, or physical leakage. We also inspect resistors and other passive components for signs of overheating. If tube arcing has occurred in the past we can usually spot discoloration on the output tube sockets. On vintage units we often spot check select capacitors for value and ESR. If the amplifier passes visual inspection, we move on to a full test of all of the tubes. We use an Amplitrex AT-1000 Tube Tester which is capable of testing both emission and Gm with a high degree of accuracy. We document the results of each tube and replace any weak or suspect tubes before proceeding. When we power on tube amplifiers for the first time we usually use a variac and current limited AC supply and slowly raise the voltage up to nominal mains level while monitoring plate, screen, filament, and negative bias supply voltages where applicable. If everything is in order we feed a low level test signal into the amplifier’s input and monitor its output on an oscilloscope across an 8 ohm dummy load. At this point we are just looking to verify basic function and confirm that the output transformers are not damaged. Once we have verified that the amplifier is safe to operate, we connected it to full mains power. For cathode biased amps we monitor the plate to cathode voltage to determine if the output tubes are operating in a safe range. Once the output section is verified we move onto bench evaluation. We start by feeding the input of the amplifier with a low level 1KHz test signal, slowly increase its amplitude while monitoring the amplifier’s output on an oscilloscope for signs of noise, clipping, distortion, or improper channel balance. We continue increasing the signal level until the amplifier reaches clipping. At this point we take an output power measurement and compare it to the spec sheet of the amplifier to verify proper performance. We finish off the bench evaluation with a 1KHz square wave check and a 20Hz to 20KHz sine sweep to assess the amplifier’s frequency response characteristics. This battery of tests will usually reveal if the amplifier has any issues that need further attention. Before the device leaves the bench, we perform a listening test with actual music using a variety of preferred test tracks. Our benches are outfitted with familiar monitor speakers which help us identify inconsistencies that will not always show up on our test gear. The main things that we are listening for are hum or noise with no signal present, proper center image, clicks, pops, or any other obvious undesirable audio characteristics. If the unit passes all of these tests it is moved to our long term testing rig where we simulate real word operating conditions for 6-8 hours. For tube amps we like to run this test at least twice. This allows us to monitor the unit for signs of thermal runaway or intermittent issues that only crop up when it has fully come up to temperature. We find this step to be essential, especially for vintage units. Please note we are not a repair shop and only restore what we own. SkyFi Audio – Curators of Vintage Audio Gear. No mid-fi, no gimmicks, no junk. Each piece of equipment is cosmetically restored and fully tested in our well-equipped lab by an engineer with 30+ years of experience in the HiFi world. Through our sister company, which is an authorized dealer for McIntosh, Audio Research, Sonus Faber, ClearAudio, Project, and Sony ES, we have access to OEM parts, service, and support. If we don’t have the original packaging, we use heavy-duty double-ply corrugated boxes with custom made to your item SealedAir Instapak expanding foam custom inserts. In many cases this has proven to be better than the original packaging! We also use high quality fiber reinforced tape to seal our packages. We have too many items for sale and it’s nearly impossible to keep track of offers outside of the official system. Our items are available for pick-up. No additional information at this time. You might also like. Dynavector 10×3 High-Output MC Phono Cartridge. Mcintosh MC2500 Solid State Amplifier – In Silver Finish! Music Reference RM-5 MK II Tube Preamplifier with Phono. Music Reference RM-9 Tube Amplifier With EL34′s.
McIntosh Tube Amplifier MC240 1960s Vintage. This item is in the category “Consumer Electronics\Vintage Electronics\Vintage Audio & Video\Vintage Amplifiers & Tube Amps”. The seller is “stevennguyen2016″ and is located in this country: US. This item can be shipped to United States.
McIntosh Tube Amplifier MC240 1960s Vintage. This item is in the category “Consumer Electronics\Vintage Electronics\Vintage Audio & Video\Vintage Amplifiers & Tube Amps”. The seller is “stevennguyen2016″ and is located in this country: US. This item can be shipped to United States.
