Vintage Tube Amp

TANGO M-705 Output Transformer Pair Set by the old Hirata Electric Tango (NOT ISO). Tested and working in my 45 SET tube amp. Used with some wear and signs of use/age. Custom finished wood covers are install on the top. Excellent for a 45 tube amp or maybe another tube amp project.

This is as clean as you will find as it was stored in a cabinet forever, barely a mark on it, and sounds super clean. I tested all tubes, replaced a couple of 6AN8s and the EL84s are all original Mullard Heathkit. Don’t want to sell it as it is that nice but have too much stereo gear.

Vintage Zenith 5G29 Stereo Tube amplifier. Uses 6BQ5 output tubes. No tubes are included. Chassis is 13 1/2″ x 4 1/2″.

All tested on hickok tester, boxes may not be the same as tube lot of 9.

This vintage NAD 7140 receiver has undergone recent servicing, testing, and is now in working order. It is a high-quality product from Japan that is perfect for vintage audio enthusiasts. The brand is NAD, with the model number being 7140. The receiver falls under the category of Consumer Electronics, Vintage Electronics, Vintage Audio & Video, and Vintage Amplifiers & Tube Amps. It is a great addition to any collection and is sure to impress with its high-quality sound.

This pair is pulled down from a working EICO ST70 tube amplifier. They are all tested, clean. I also have its power transformer. Price is for a pair!

Vintage Dynaco Dynakit Mark III KT88 Stereo Amplifier. This amplifier has been tested and serviced and is in good working condition. Has a set of Svetlana Power Tubes, one is labeled McIntosh and the other straight Svetlana. The 5AR4 Rectifier is an American Made Westinghouse, and the 6AN8 is a Sylvania. True Dynaco Dynakit MK III Monoblock manufactured in Philadelphia. One of the most highly regarded vintage audio tube amplifiers ever built.

Dusty but looks to have all inside pieces.

It was rated at 40 watts RMS (20 watts in triode), with two (2) EL34 output tubes. This listing includes one. Vintage Marantz Model 2 Tube Mono Amplifier as shown. The chassis shows signs of corrosion on the top plate with some of the original silk-screening being affected; but most of the print is still present. The tube cover is included; but is missing the grommets to hold it in place. Therefore the cover is loose and not properly affixed to the amp. This particular amplifier is in tested working order; but comes with no guarantees. It should be completely checked out by an experienced (tube) technician before being placed into normal use. All of the tubes shown in photos are included; but none are branded or screened. One 6AU4-GTA has some loose particles inside; and one EL34 is slightly crooked. Please review all attached photos; and be sure to ask any questions. The amplifier will be Very Securely Double Box Packed with High Quality Packing Materials for Safe Transit and No Worries for a Safe Arrival. Power output: 40 watts into 8? (mono). Frequency response: 20Hz to 20kHz. Total harmonic distortion: 0.1%. Input sensitivity: 0.7V. Signal to noise ratio: 90dB. Speaker load impedance: 4? To 16? Valve complement: 1 x 12AX7, 1 x 6CG7, 2 x EL34, 2 x 6AU4GTA. Dimensions: 15 x 9.5 x 6.5 inches. If you are in one of these locations – please message for rates.

This Type 122 tested and removed from a fully functioning Leslie cabinet we part off. The one stop place for Leslie! Every parts are tested and are from a fully working Leslie! Great tube socket and connector.